Activity Stream

It does sound like an earth problem with the gauges reacting like that

Cheers guys. Yes voltage regulator for three gauges And I have been through the dash loom with a multi meter and all seems to be correct. It...

Tommy - Did you install a voltage regulator with your gauges, just a thought this hasn't packed up? Barry

Have you checked the wiring behind the dash? earthing is one point, but if you have moved the dash, one wire may be adrift or contacting another??...

Ah. Pulling plugs isn't so easy then. But I think you've covered the rest of the bases. Just a thought: Did this missing and backfiring problem start...

Does CBS, stand for Car Builder Solutions? YES IT DOES! mine is wired as above but the live feed is the one to the dash indicator warning light...

Andy, Not sure whether this will be of any use or not, so anyway – I am building a similar car - Mklll Sumo with Granada running gear & a...

Did this swap to my mates car and just cut off the cone thats on the 2" perforated tube and welded it onto the 3" once cut so the opening was 3" on...

Thanks Brian Love you too. Hows the new toy going (if it is still working that is:lol::lol:)

BTW - you are in good hands in Tinka and Dingo but beware: Tinka will talk you into doing countless mods to the car and Dingo will leave you with...

Hi Darren, your statement above may go some way to explaining why I did not wee the problem that often :wink: The Speed Demon carbs all seemed to...

PM sent Kev.

No problem if you want you can pop over or I can take it with me to Steve's. Sending PM

I can't remember exactly how it's done now, I think you use the supply for the lights as an earth which it is until you turn them on:confused: but if...

Hi Martin, The nearest thing I have got to a vacuum gauge is a Dyson but I don't think that will help me. To be honest I wouldn't know what to...

I have a buzzer fitted to mine. I have a GD which uses a dash mounted switch for the indicators - 3 position - up middle and down. Of course this...

Hi Henry, thank you for your advice. I do have a bit of barsterd problem. I can't actually get a compression kit on the damn thing. To remove two of...

what sort of money, Paul? pm me if its easier. I have a mech pump atm, but might be nice to have these 'on show'.

Wow Cliff you are a star. Thank you

Hi, Yes, see Excel file at: http://www.cjgraves.com/speedo_calibration.xls Enter your variables for: Tyre Width Tyre Profile Tyre Size Diff...

Instead of everyone just saying they would support it how about someone organise it. ;-)

The buzzer i have bought seems quite loud, but I will test it to make sure it is loud enough before i go to the trouble of wiring it in . If it is...

Not a RAM - it has visible / external boots hinges. RAM has internal hinges.

Thanks for a swift answer Cliff, that really helps Note your point re axle stands!!!! But no, I don't yet have the calculation for programming my...

Hi, 1) Yes, if the plug fits OK, it should be fine 2) Ignore the Yellow/Blue wire in the loom. Run two new wires from the Tremec switch to pins 7...