PDA

View Full Version : Cost of a Flywheel?



garyholden
10-06-05, 10:10 AM
I can get a brand new flywheel from the states for my SBC 350 for $207 inc. (120) shipping.

Is this a good price? I have tried to source one from the UK but no luck

Thanks
Gary

Grease Monkey
10-06-05, 12:22 PM
I ended up paying 115.83 for mine (153 tooth, 12.75 inch, 3" bolt pattern) from Brian at Repower, so 120 sounds competitive.

Viper
10-06-05, 12:30 PM
I have a flywheel for a SBC its for a pre 1986 engine and the center hole is 62 mm, is this any good to you?

garyholden
10-06-05, 02:51 PM
I have a flywheel for a SBC its for a pre 1986 engine and the center hole is 62 mm, is this any good to you?

I dont know yet but I'll check. Is there any numbers on it?


Thanks
Gary

salmon
10-06-05, 04:03 PM
Hi Gary,

Measure the diagnonal spacing of the bolt pattern, there are only two sizes 3.00" and 3.58".

Pre-86 are all 3.58" spacing.

Regards
Chris

donington pete
10-06-05, 06:10 PM
Gary, I have a new flywheel, as described, numbers are GM 22 and 3791021. It is 153 tooth and 3 5/8 p.c.d. Seventy five quid seems fair.

Viper
11-06-05, 09:51 AM
I dont know yet but I'll check. Is there any numbers on it?


Thanks
Gary

Gary the flywheel has 168 teeth and the spacing is 3 5/8 for the bolt holes, I might be going to the grasshopper this Sunday, that is if I dont do the L2B,