View Full Version : Another Flea bay find to make intake box

01-07-10, 12:11 PM
I found these again on eBay and manged through some yorkshire bidding get them both for 23 delivered, especially chuffed I was looking to buy from an online store at 35 each.

There are different in appearance (lay of carbon pattern) which at first I was a little disappointed but then thought well its carbon fibre its meant to look handmade, isn't it?

anyhoo I am going to shorten them to 300mm and use the excess to create a T-piece air filter housing with the T pointing up to the scoop with K&N cone filters just to be different. Or I will run via flexi hose to front of car if it won't go.

What do you all think?


01-07-10, 07:50 PM
nice, but make sure you wear a mask and eye protection when you cut it.