PDA

View Full Version : HELP water pump pulley needed for Ford 302 - single V



Peranaman
03-05-12, 07:50 PM
Hi Guys,

Off to France next week in the Perana - an hour ago the water pump pulley just decided it doesn't want to go to France with the rest of the car!!

Anyone got a pulley like the one in my pictures?

1971 vintage Ford 302.

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/DSCF4045.jpg

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/DSCF4043.jpg

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/DSCF4042.jpg

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/my_alternator_1.jpg

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/DSCF1690.jpg

http://i239.photobucket.com/albums/ff190/peranaman/Perana/pulleys/DSCF1689.jpg

Bit urgent - thanks Chris

kdavies3
03-05-12, 08:12 PM
You could have one here from the states very quickly if you pay the shipping.
from Summitt Racing.
When do you leave?
I can measure my FE one which looks similar.

Peranaman
03-05-12, 08:15 PM
You could have one here from the states very quickly if you pay the shipping.
from Summitt Racing.
When do you leave?
I can measure my FE one which looks similar.

Hi Kev - I'm in Bridgend. Need it like yesterday - have lots to do!! cheers Chris

kdavies3
03-05-12, 08:26 PM
Hi Chris the FE one is 7.25" dia, and 2.4" deep.
So unfortunately it isn't going to work for you chap. :(
If I were you I'd have that one repaired to get you out of the crap.
There's a place in Bridgend that could do it I'm sure (on Brackla Ind Est).

Peranaman
03-05-12, 09:22 PM
Hi Chris the FE one is 7.25" dia, and 2.4" deep.
So unfortunately it isn't going to work for you chap. :(
If I were you I'd have that one repaired to get you out of the crap.
There's a place in Bridgend that could do it I'm sure (on Brackla Ind Est).

Kev - I'll try Real Steel tomorrow.

Then I'll get one made in stainless later on.

thanks Chris

ps the offset on my pulley is too far forward anyway. So it'll be an opportunity to inset it a couple of mil to line up better with crank pulley.