PDA

View Full Version : including a electronic fan controller in Dax wire loom



Cobra power
25-10-04, 08:19 PM
I'm using a fan with an electronic fan controller. Can I use the fan wires in the Dax loom to connect the fan? Or will this include the 'original-loom' fan switch in the circuit ?:confused:

If so, should I bypass this 'original' switch or use a different power source?

Thanks

kdavies3
26-10-04, 11:34 AM
The Dax loom has wires for the fan controller which operates the relay and a pair of thicker Power wires to the fans themselves. Orange and black from memory.

dave
26-10-04, 07:27 PM
Also the Dax loom is fitted with a relay for the fan that is triggered by the adjustable fan switch (Thin wires black and orange/black). To bypass this switch just connect these two wires together, this will put the fan in the permanently ON position. Or if you are after controling the fan by another method then use these two wires..............If you know what I mean.:thumb:

Cobra power
26-10-04, 08:51 PM
thanks again!