• Categories Widget (Show All)

  • Recent Articles

  • Recent Forum Posts

    GDCobra

    Rover V8 Gearbox advice - R380

    I did retract that in a later post after finding a photo, my clutch/flywheel does not look so different. However I do agree that taking them out of the

    GDCobra Today, 06:54 PM Go to last post
    AlexB74

    When is a Newbie not a Newbie ?

    Seem to remember there’s something iffy about the recommended/standard pilgrim rv8 plumbing set up in the mk3’s - can’t remember what the fix is?

    AlexB74 Today, 06:43 PM Go to last post
    drammyboy

    Rover V8 Gearbox advice - R380

    GD could be on to something with the clutch

    Your clutch cover looks a bit thicker than what I fitted.

    Once again....a trial

    drammyboy Today, 06:32 PM Go to last post
    GDCobra

    Rover V8 Gearbox advice - R380

    Why is it going to move the splines out of the clutch plate? I thought we'd established that due to your shaft being too long you can't get the bell

    GDCobra Today, 06:26 PM Go to last post
    Grumbleweed

    Rover V8 Gearbox advice - R380

    Yes, packer between gearbox and bell housing certainly seemed the neater option to me but this takes me back to the original issue and would effectively

    Grumbleweed Today, 06:21 PM Go to last post