• Categories Widget (Show All)

  • Recent Articles

  • The UK Cobra Forum

    Welcome, The Cobra Forum has over 1200 forum members who either own or are building a 427 Cobra Replica, 289 or Daytona Cobras.

    The Cobra Forum is dedicated to the AC Cobra Replica Marque, comprising the Shelby Cobra and the 289. The Cobra Forum site has a whole host of great information and a very active forum for members and enthusiasts.

    Membership is split between Cobra Replica owners, people who are currently building a cobra and those who are just interested in the cobra marque. The overall aim of the Cobra Forum is to give moral, and hopefully technical support to builders and owners, organising car show attendances, social events, group holidays and whatever members are prepared to organise on a voluntary basis.

    We have a wide range of sections within the site, but to use all of them you will need to register. Registration on the site is free.
  • Recent Forum Posts

    Ian C

    Plumbing a 1UZ into a Sumo

    Jon,

    Thanks for the response and the link. Noted that there were a couple of comments, below the video, questioning the need for the

    Ian C Yesterday, 11:09 PM Go to last post
    TonyD

    Plumbing a 1UZ into a Sumo

    On the LS400 the pipe you have circled in the photo goes down to the water/ oil cooler assembly on the oil filter housing.

    If you are running

    TonyD Yesterday, 10:18 PM Go to last post
    Russ-Notts

    East Midlands Cobra Club

    Thanks Charlie. I don't have a specific time to leave tomorrow. Just a case of setting off when I'm ready as I still have a few things to sort out in

    Russ-Notts Yesterday, 08:21 PM Go to last post
    Darnpistonbroke

    5 speed gearbox

    Hi. I am after a 5 speed gearbox for my Chevy 350 powered Dax. At the moment I have a 4 speed Saginaw so I have a bell housing.
    Anything out there?

    Darnpistonbroke Yesterday, 07:40 PM Go to last post
    Chris1

    Starter Motor ‘Flat-Spot’

    Hi Craig,
    I would check the out of mesh clearance ,most starter motors are about an eighth of an inch.
    Also check the obvious things like

    Chris1 Yesterday, 07:30 PM Go to last post