• Categories Widget (Show All)

  • Recent Articles

  • The UK Cobra Club RSS Feed

    There is no content in this section

  • Recent Forum Posts

    Ian C

    Plumbing a 1UZ into a Sumo


    Thanks for the response and the link. Noted that there were a couple of comments, below the video, questioning the need for the

    Ian C Yesterday, 11:09 PM Go to last post

    Plumbing a 1UZ into a Sumo

    On the LS400 the pipe you have circled in the photo goes down to the water/ oil cooler assembly on the oil filter housing.

    If you are running

    TonyD Yesterday, 10:18 PM Go to last post

    East Midlands Cobra Club

    Thanks Charlie. I don't have a specific time to leave tomorrow. Just a case of setting off when I'm ready as I still have a few things to sort out in

    Russ-Notts Yesterday, 08:21 PM Go to last post

    5 speed gearbox

    Hi. I am after a 5 speed gearbox for my Chevy 350 powered Dax. At the moment I have a 4 speed Saginaw so I have a bell housing.
    Anything out there?

    Darnpistonbroke Yesterday, 07:40 PM Go to last post

    Starter Motor ‘Flat-Spot’

    Hi Craig,
    I would check the out of mesh clearance ,most starter motors are about an eighth of an inch.
    Also check the obvious things like

    Chris1 Yesterday, 07:30 PM Go to last post