• Categories Widget (Show All)

  • Recent Articles

  • The UK Cobra Club RSS Feed


    There is no content in this section

  • Recent Forum Posts

    alunwill

    1UZ-FE: Lambda variation between banks

    It's just the amount of peripheral bits which you need to take off that takes the time òn a Lexus. Driver side a bit o of a pain because of the air input

    alunwill Today, 05:27 PM Go to last post
    alunwill

    VDO dip tube sender

    It's a while since I put mine together but from memory I think you calibrate the gauge which produces one table and then you calibrate the sender with

    alunwill Today, 05:22 PM Go to last post
    KevinW

    Thought I'd say Hi

    or, as you are in Scotland, if you are handy with a welder, they might supply the bits.
    Its well-worth having done - the handling on my old early

    KevinW Today, 05:19 PM Go to last post
    GDCobra

    dot dot dot -dash dash dash- dot dot dot

    Apart from the rather dodgy looking shroud over the centre (and bearing in mind it's obviously not yet finished) I think that looks OK. Not what I'd

    GDCobra Today, 05:13 PM Go to last post
    dgosumo

    Thought I'd say Hi

    The Mk3 had additional triangulation on most of the corner joints and some additional bracing underneath and at the front. Have a look here: How to build

    dgosumo Today, 05:09 PM Go to last post