• Categories Widget (Show All)

  • Recent Articles

  • Recent Forum Posts


    Smiths Speedo dropping out

    thanks for the tips. I'll have another look at the position of the sensor. On my first visit to the DVLA, the sensor was too close to the bolts, it got

    Mark_Robinson Yesterday, 09:02 PM Go to last post

    Re-gassing struts.

    It really depends on the geometry: where the strut is attached and the angle. I'm not sure it is useful to just compare load values.

    mylesdw Yesterday, 08:30 PM Go to last post

    Classic Replica Build

    Underside of bonnet filler sanded and then etch primed.

    There are some minor imperfections that need attention/filler.

    KugaWestie Yesterday, 07:50 PM Go to last post

    Re-gassing struts.

    Thanks Andy, that’s helpful shows I’m not a million miles away...or Newtons.

    Dek Yesterday, 07:42 PM Go to last post

    Self centering

    Yes, to prevent the wheels touching the arch.

    Pipe clamp under the gaiter, clamped to rod end (but I think the problem was there before

    cperry Yesterday, 07:35 PM Go to last post