offset information

maverick · #1 (**permalink**) 21-04-03, 11:56 PM

Anyone know the wheel offset information for the Dax and preference of width front and rear?

STEVE G · #2 (**permalink**) 22-04-03, 01:36 PM

Dont know the offset but fronts are 9"x17" and rears 10"x17".
Dax standard offset will suit any make with narrowed axle.I've jut taken delivery of a set from Dax and they fit my GE perfect.
Steve G {-}
GE427-Rover 281ci.

martin · #3 (**permalink**) 22-04-03, 07:49 PM

Believe the offset is a.. front - 7/8"offset to move rim inwards.
rear - 7/8" offset to move rim outwards.

Picked my wheels up from Dax last friday,look the business!!! getting the tyres tomorrow.

maverick · #4 (**permalink**) 23-04-03, 12:31 AM

The 17" on your car look great but I think I'll stick to probably 16".
I've a Dax body going onto my SR chassis so I just hope the offsets are the same 'cause I think SRs body was a Dax clone.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
wheel offset	viperjim	General Cobra Discussion	1	09-10-07 11:27 PM
Wheel PCD and Offset	kevchard	The Cockpit	0	26-11-06 12:24 PM
Correct Wheel Pcd And Offset	jiz	General Cobra Discussion	2	08-08-06 07:35 PM
Wheel Offset	cheepskate	Pilgrim Sumo Technical Questions	12	24-07-03 02:47 PM
offset information?	maverick	General Cobra Discussion	3	12-05-03 10:45 AM