Need a new SD1 Thermostat housing

[Dave Williams]

ello,

anyone tell me where I can get a new SD1 thermostat housing?

Needs to be the same as the std car fit i.e. pointing around 45deg upwards and forward towards the driver side of the car. The one i've got has corroded at the hose joint area and so leaks...! :boohoo:

I tried Real Steel since a thread here said they did a cast one but they say they don't... can't be arsed to go to Rimmer Bros just yet...

[Purple AK]

http://www.rimmerbros.co.uk/cgi-bin/...engine/cooling :thumb:

[rich]

your post is a little baffling to say the least Dave

If you can't be arsed to get one from Rimmer Bros, how should people know where to tell you, that you can be arsed to get one from?

[TINKA]

Rimmers is your best bet so when you can be arsed thats the place to go.

[wilf]

Look at it this way.

In terms of the "can't be arsed" hierarchy, CRC Forum members are way above Rimmer Brothers!

Now all I have to do is establish if that is a good thing or bad.

[jrv8]

Hi,
Do you need a by-pass pipe on it , or is it just the standard SD1 thermostat housing you're looking for ?
Could you be arsed to buy a used one ?
Jim

[Dave Williams]

mmmmmm maybe my humor was slighly too vague even for the CRC.. re: not being arsed with Rimmers ..... :rotfl:


ok ok - I geddit - so you are all happy Rimmers ....

ahem... I shall go forth and buy.... thnx

[Dave Williams]

hi

rimmers no stock... jim I'll be callin you.... ;o)

[Dave Williams]

thanx Jim, it arrived today - nice one! :thumb:

[jrv8]

Originally Posted by Dave Williams

thanx Jim, it arrived today - nice one! :thumb:

Hi Dave,
Glad to be able to help , and thanks for getting back to me.
Regards
Jim