Dax Loom

[BenBaron]

hi all,

dont know if I should have but I've gone and ordered myself a sh*t load of headaches this morning...

Prepare for a barrage of questions {-}

[kdavies3]

Don't panic Ben, it'll look horrendous like a tangled bunch of worms.

Your best bet is to lay it out on the floor and look it over whilst reading the instruction manual that'll come with it.

All should become clear eventually. }(

[Happy Jim]

Use Beer liberally during thought process

[BenBaron]

Both sound like jolly good ideas{-}

see ya

Ben

[BILKO]

Ben

You think you've got problems, I'm about to start my Dax loom tomorrow, been putting it off for ages cos I'm colour blind & slipdexick (only joking) but really not looking forward to doing the loom.

Luke ¦-0

[BenBaron]

I might some pointers off you then when youve finished


{-}

[dave]

Luke/Ben.
If you have any problems, ring me before you cut the wrong wire off.
07785 702005.

[BenBaron]

wadda mean 'cut' ???? I wont be doing anything like that!


still not come this morning, I hate delivery guys, they rang yesturday saying they would deliver yesturday but bet they have sent it back by now.

[TonyD]

Easiest way of sorting the loom out I found was to lay the thing on the floor and using the wire listing/ colour coding and some sticky labels, methodically label up each wire at its termination point.

After a few minutes the layout becomes clear and when it is installed in the car you have the labels to ensure you connect up the right wire to the correct bit of kit.

Cheers,

Tony

[salmonc]

Hi Guys

Speaking of Dax Wiring looms, I am part way through installing mine in the car but I have mislaid the wiring schedule. Could somebody please photocopy one and send it to me please. I dont really want to attempt the dash without it!.

Chris