chevy 383 stroker

[petecob]

I bet you people that run a stroker engine know what cam you have fitted, can you let me know which one and what h.p. you are getting.Found a crack in my block after rockingham, so im looking at putting a new short engine together.
Thanks Peter.

[kdavies3]

Mines an Edelbrock Performer RPM jobbie along with the rest of it.

[petecob]

Been told that the rpm. cam is a bit lumpy.

[roll control]

Edelbrock Performer rpm heads, Victor Jnr inlet manifold, Doug Herbert cam, 427 hp, 440 lbs/ft torque


Rob

[mikey]

Crower 290 R Grind 00427 Solid Roller. Anticipated 500 to 520 HP with Victor Junior Inlet and AFR 210 heads on Mowtown 415.
Mike.

[JamesP]

Comp Cams dual profile hydraulic roller 12-423-8, retro fit for non roller cam blocks, rollers are a piece of art, a bit expensive though.
Looking for 420HP plus, running with an EFI setup so should stabilize the idle a bit (though the guys in US would think this cam was mild) Dyno2000 has setup @ an optimistic 480HP
224/230 @ 0.050" .502/.510 lift, 110 LSA

AFR 195cc heads, Accel MPFI single plane intake, 10.2CR, forged crank/pistons and H beam rods

James

[PAULGD]

I had a cam supplied by Lazer cams in the states; which was specially made up for me and returns a true 420 bhp and 450 ft/lbs torque. (tested on a english dyno!!). Runs really smooth throughout the rev range. (even the wife can drive it.)
If your interested contact me and I`ll put you in touch with their English supplier.
Paul