dax wiring positions

[markieboy]

Hello again, ive spent ages marking up my dax wiring loom and now its time to fit it!!! Gulp!
Im using a rover v8 lump and was wondering where is the best place to take the wires through the bulkhead. Ie left or right hand side viewed from sat in the car.
Any helpfull advice would be appreciated.

Hopefully fitting the engine just after christmas!!!

Thanks in anticipation

Markieboy

[john w]

Hi Markie

I have just started fitting the front section of the harness for a chevy went down the O/S, & it fits great, & put the fuse box through the bulkhead.

I have also wraped the harness in black spiro, to protect & look better.

John

[markieboy]

Thanks John.

Its along the same idea as I had offside along the bonnet lip with the fuse box mounted to the left of the drivers position but in the engine bay if that makes sense.
I want to get all the cutting done as Im off to collect the engine hoist for exciting times..

Thanks again