Holly Help Needed

[Andy S]

Got all the winter mods sorted so far, and its great to have the beast back on the road.
Problem......
I'm running a 600 cfm holley and the smell of fuel from the sidepipes is making my eyes water and thats at speed
Ive looked at the holley book and it shows a diagram detailing the 'mixture adjusting screw' on page 12.
Can I find it in the exploded diagram at the back, can I buggery.
Can I find it on the carb, in a nutshell NO.
Help where is the little bugger located????????
I NEED TO SEE WHERE I AM GOING, NOT WIPING MY EYES

[Purple AK]

Inbound Phone Call

[Miket]

Andy

There should be 2 Idle mixture screws, 1 on each side, the one on the right looking from the drivers seat is just behind the fuel level site plug and just below the timed spark port, the one one the other side is in the same place.

[Clarkson]

Here is a pic M8.The screws next to the carb mounting studs,I have 4 of them,but you will only have 2 on the front, one on each side.

[Purple AK]

From Andy's description on the phone it sounds like float adjustment as it is all through the rev range. He's on the case

[Andy S]

Cheers for the replies guys, and for the call Chris.
Hopefully get it sorted tomorrow and give her a run, they say its going to be sunny so shame to waste a good day