• Categories Widget (Show All)

  • Recent Articles

  • Mitch

    There is no available content written by Mitch
  • Recent Forum Posts

    drammyboy

    implementation of RV 4.6

    Photo from the web should explain the position of the holes - helping the front end parts stay cool

    If you are rebuilding the engine then

    drammyboy Today, 01:24 PM Go to last post
    aaronjb

    Dial in Bellhousing HELP!

    I'm in the wrong line of work.. even for me, I reckon that's about an hours work on the lathe - I think for someone doing lathe work regularly, about

    aaronjb Today, 01:11 PM Go to last post
    Julesdm

    Dial in Bellhousing HELP!

    We did and it was true......i will double double check again later today.

    Julesdm Today, 01:05 PM Go to last post
    GDCobra

    Scissor lift

    Looks similar to mine that except it looks like it has a a pole which extend out the top as it lifts which may be an interference issue with ceiling,

    GDCobra Today, 12:56 PM Go to last post
    GDCobra

    Dial in Bellhousing HELP!

    I agree. Even if that reading is TIR it would mean the crank centre has migrated over 1mm, bell housing fit would be the first of many problems. In precision

    GDCobra Today, 12:45 PM Go to last post