• Section Widget

  • Categories Widget (Show All)

    Article (0)
    Buyers Guide (1)
    Club (3)
    Forums (0)

  • Recent Articles

  • cperry

    There is no available content written by cperry

  • Recent Forum Posts

    aaronjb

    Ford v8 fe / ft engine 1973 d3te-i

    Indeed - the only place I have any room is up front, where (especially in a standard chassis) there would be acres of room.. well, relatively speaking!

    aaronjb Today, 10:58 AM Go to last post
    ChrisP

    Ford v8 fe / ft engine 1973 d3te-i

    Useful bellhousing that as you can access the clutch and centre bearing via the bottom plate which is removable.
    Yes, an FE is tight in a Dax but

    ChrisP Today, 10:23 AM Go to last post
    aaronjb

    Service Schedule?

    I once had a slight accident with a puddle of gearbox oil (driveshaft fell out of my old Renault 5 ) - the jumper I was wearing never did recover!

    aaronjb Today, 09:39 AM Go to last post
    aaronjb

    Ford v8 fe / ft engine 1973 d3te-i

    There's two of us with an FE in a Dax now .. well.. one and a half? Since mine isn't finished. I can certainly tell you that it's a tight fit. A very

    aaronjb Today, 09:37 AM Go to last post
    jon1d

    Ford v8 fe / ft engine 1973 d3te-i

    Been looking at the 390 FE option for a build and would put ali heads There are so many cast iron heads usually the truck one are restrictive but solid

    jon1d Yesterday, 08:57 PM Go to last post