• Categories Widget (Show All)

  • Recent Articles

  • braincol

    There is no available content written by braincol
  • Recent Forum Posts


    SRV8 door fitting

    Just wondering for those with SRV8's and a good memory if anyone has any tips on door fitting and alignment. I am now getting my car ready for painting,

    pevans Today, 08:20 PM Go to last post

    Classic Replica Build

    I always use heat shrink which is quicker, neater and no chance of tape coming loose. Use a hot air gun or the soldering iron shaft not the iron tip .

    jon1d Today, 08:15 PM Go to last post

    Earth straps attachment of....

    Thanks Jon, I will need to use a mild steel fixing to the chassis as I need to self tap into it, have some hex head self tapping m8 coach screws, was

    JamesB Today, 08:01 PM Go to last post

    Classic Replica Build

    Dashboard wiring is almost complete, just a couple more cables to sort on the warning lamps

    Resistors soldered onto

    KugaWestie Today, 07:39 PM Go to last post

    Rear end rebuild

    Manual indicates 304-336 Nm for Axle Shaft Hub Nut

    BobMin Today, 05:56 PM Go to last post