• Categories Widget (Show All)

  • Recent Articles

  • rpm015

    There is no available content written by rpm015
  • Recent Forum Posts

    simon

    Bumper grommets

    How about oval stainless steel escutcheons to cover the area around the nudge bar supports? I’m sure I’ve seen them on some cars, they’d cover up

    simon Today, 05:37 PM Go to last post
    jon1d

    Clutch slave cylinder

    My clutch is heavy and was looking at remote servo's to lighten it for the Misses to drive as she said f## what is that the brake haha. Not changed it

    jon1d Today, 05:19 PM Go to last post
    Darnpistonbroke

    Clutch slave cylinder

    By the looks of it I'm I have a 3/4" master serving a 5/8" slave. Very heavy pedal and as said earlier, the bulkhead is only fibreglass which

    Darnpistonbroke Today, 05:04 PM Go to last post
    TINKA

    Clutch slave cylinder

    That's what I run in mine although the clutch pedal in mine is very heavy I'm used to it now so I don't even notice it most of the time.

    TINKA Today, 04:28 PM Go to last post
    Darnpistonbroke

    Clutch slave cylinder

    The clutch I have fitted is a McLeod which is a cut above the norm.
    The usual arrangement is 3/4” master with a 7/8” slave or so I thought?

    Darnpistonbroke Today, 02:32 PM Go to last post