• Categories Widget (Show All)

  • Recent Articles

  • skinnymathew

    There is no available content written by skinnymathew
  • Recent Forum Posts


    Aaron's Dax De Dion build thread

    You could 'flex' the P clip, but not spin them round - I think the tester would have snapped the bonded in fixing out of the reflector before that (and

    aaronjb Today, 01:57 PM Go to last post

    implementation of RV 4.6

    Photo from the web should explain the position of the holes - helping the front end parts stay cool

    If you are rebuilding the engine then

    drammyboy Today, 01:24 PM Go to last post

    Dial in Bellhousing HELP!

    I'm in the wrong line of work.. even for me, I reckon that's about an hours work on the lathe - I think for someone doing lathe work regularly, about

    aaronjb Today, 01:11 PM Go to last post

    Dial in Bellhousing HELP!

    We did and it was true......i will double double check again later today.

    Julesdm Today, 01:05 PM Go to last post

    Scissor lift

    Looks similar to mine that except it looks like it has a a pole which extend out the top as it lifts which may be an interference issue with ceiling,

    GDCobra Today, 12:56 PM Go to last post