• Categories Widget (Show All)

  • Recent Articles

  • jon1d

    There is no available content written by jon1d
  • Recent Forum Posts


    clutch required

    Anyone know where i can get a new clutch assy for my 350 chevy, its got a 153 tooth standard flywheel with a machined face of about 10.3/4 inches. i am

    methoni Today, 10:42 AM Go to last post

    AK air filter choice.

    I used one from Real Steel - Mr Gasket Low Rider 14" - part no BY4339

    Inzapp Today, 10:15 AM Go to last post

    Oil everywhere!!!!!!

    Dave thank you for this. On my desperate trawl through the interweb i found this to be number 1 potential fault.....i must say the oil seems to favour

    Julesdm Today, 10:11 AM Go to last post

    EFI - Fitech, Holley Snipe, etc

    Hi Bernie, Did you read my message in your pm box

    neville Today, 09:05 AM Go to last post

    Oil everywhere!!!!!!

    On the front of the block next to where the fuel pump would be mounted there are two tapped (3/8 UNC) bolt holes.
    Often one of these holes

    dave Today, 07:00 AM Go to last post