• Categories Widget (Show All)

  • Recent Articles

  • robert

    by Published on 22-03-11 11:47 PM
    1. Categories:
    2. Club

    Welcome, The Cobra Forum has over 1200 forum members who either own or are building a 427 Cobra Replica, 289 or Daytona Cobras.

    The Cobra Forum is dedicated to the AC Cobra Replica Marque, comprising the Shelby Cobra and the 289. The Cobra Forum site has a whole host of great information and a very active forum for members and enthusiasts.

    Membership is split between Cobra Replica owners, people who are currently building a cobra and those who are just interested in the cobra marque. The overall aim of the Cobra Forum is to give moral, and hopefully technical support to builders and owners, organising car show attendances, social events, group holidays and whatever members are prepared to organise on a voluntary basis.

    We have a wide range of sections within the site, but to use all of them you will need to register. Registration on the site is free.
  • Recent Forum Posts

    Gatwick Axe Man


    Pictures please when it's done, would like to do this to mine.


    Gatwick Axe Man Yesterday, 09:27 PM Go to last post

    Exhaust manifold fitting

    The point at which i place the packing will be on the flat section of the engine mount, this in theory will raise the engine by the required

    methoni Yesterday, 07:34 PM Go to last post

    Exhaust manifold fitting

    Don’t forget if you plan to use packers between the engine mounts and block, if the mount pads on the block are at an angle then packers won’t work.

    Darnpistonbroke Yesterday, 07:12 PM Go to last post

    Goodwood meet

    Looking forward to port solent tomorrow (Noisy red pilgrim with all the stickers).

    I’d aim to be early... lack of car events, COVID

    AlexB74 Yesterday, 05:09 PM Go to last post

    Exhaust manifold fitting

    I think my setup will be slightly different because i have a carb. engine so no cats, my problem will be getting the pipes off the chassis

    methoni Yesterday, 03:42 PM Go to last post