Yes, the whole unit is bolted onto the chassis. Some of the brackets & fabrication might be a little on the light side. I was looking to see if anyone
brianskybolt Today, 07:52 PMYes it is, but what it bolts too or the lack of what it bolts to is the problem.
Chimeara Today, 07:45 PMNot replaced a seal Dek but I would suggest Chris Glover at Brasscraft may be a good place to start.
Charlie
Isn't the rear end just the standard Sierra rear beam setup bolted up to the Euro427 chassis?
skinnymathew Today, 06:18 PM
Suspension setup, Fiero Euro427 ThnksCobra
I still can’t Believe the main pick ups are on inch x inch box section tack welded along one edge.
Chimeara Today, 08:12 PMThat’s the bits I triangulated,