• Categories Widget (Show All)

  • Recent Articles

  • Buyers Guide

    There is no available content in category Buyers Guide
  • Recent Forum Posts

    aaronjb

    Clutch slave cylinder

    Your description of the mounting bracket gave it away .. and I thought "I'm sure I've seen that somewhere.." - I've stared at their page of

    aaronjb Today, 06:48 AM Go to last post
    mrkawamackie

    Bumper grommets

    After a LOT of searching I found these for my AK. Although not oval, they're a bit softer than usual grommets so have some flex meaning the oval hole

    mrkawamackie Today, 06:38 AM Go to last post
    dave

    Clutch slave cylinder

    I'm pretty sure that is the only size available.
    If you use a larger bore slave you will usually find that there is not enough travel to fully dissengage

    dave Today, 06:24 AM Go to last post
    KugaWestie

    Classic Replica Build

    Thanks Fella's

    Yes I had thought about the screen when I started chopping. I decided to do it anyway and then offer the screen up once reshaped.

    KugaWestie Today, 05:40 AM Go to last post
    TINKA

    Classic Replica Build

    When Iain had his car painted he didn't have quite so bad a fit as you on the passenger side but due to the way the windscreen fitted he did have to raise

    TINKA Yesterday, 11:24 PM Go to last post