• Categories Widget (Show All)

  • Recent Articles

  • Buyers Guide

    There is no available content in category Buyers Guide
  • Recent Forum Posts


    Exhaust manifold fitting

    Don’t forget if you plan to use packers between the engine mounts and block, if the mount pads on the block are at an angle then packers won’t work.

    Darnpistonbroke Today, 07:12 PM Go to last post

    Goodwood meet

    Looking forward to port solent tomorrow (Noisy red pilgrim with all the stickers).

    I’d aim to be early... lack of car events, COVID

    AlexB74 Today, 05:09 PM Go to last post

    Exhaust manifold fitting

    I think my setup will be slightly different because i have a carb. engine so no cats, my problem will be getting the pipes off the chassis

    methoni Today, 03:42 PM Go to last post


    i have now determined that the handbrake cable that attaches to the xjs handrake is long enough to be rerouted to a position on the centre tunnel so with

    bw41059 Today, 02:51 PM Go to last post

    Exhaust manifold fitting

    This was my biggest fear, however i now understand the process.
    See www.russhowell.com for pictures of my build. I did the exhausts approx 2 months

    Russhowell Today, 02:25 PM Go to last post