ford TKO clutch alignment tool

[snake_bitten]

Does anyone have the 17mm pilot 26 spline alignment tool for me to borrow? I have seen them in kits in the US. lloks like the end of an input shaft with a finger ring on the end.

Thanks in advance. would like to hopefully fit new box this weekend.

[dingocooke]

A piece of bar and insulating tape has worked for me on countless installations, its what most garage guys use. After all youre only lining the friction plate up statically so you can get the gearbox iput shaft in the crank bearing.
Very inexpensive too! Otherwise summit do plastic (yuk) ones that are cheap, and I think real steel do too. Halfords sell a Draper tool with a series of little adaptor collars, which usually fit nothing, and you then wrap them with tape to get the right size!