Finishing the upper bulkhead.

[Marty V6]

Originally Posted by Gazzab

Thanks Marty i will use the method you suggest, where did you get the machine finish s/s sheeting from ? i have been looking for some today without any luck.
Gary

Hi there,
I got it from Europa Spares, they do a few different types.
To stop it from tarnishing, I cleaned it up as best I could, and then clear laquer coated it using standard rattle tins from Halfords.

Cheers

Marty

[Marty V6]

Originally Posted by chedz

Hello, I like the idea of being able to remove it, better than the foam solution I think.

I've added it to the site, hope you don't mind me copying your pictures

bulkhead

You can get a wide range of stainless sheets from ebay, with a range of finishes, its not cheap though.

cheers

Fame at last - or is that infamous at last. Whichever, yes please use the photos, I put them on in the hope that thay might help.

Cheers

Marty

[Gazzab]

Originally Posted by Marty V6

Fame at last - or is that infamous at last. Whichever, yes please use the photos, I put them on in the hope that thay might help.

Cheers

Marty

Hi Marty,

Fame or infame what the heck, i tried to get s/s machine finish from europa but they say that they only do ally sheet in the finish you have used So i guess you have used ally, next to find somewhere to hire a rivnuter from.

Gary

[Marty V6]

Gazza,

Oops, I think I may have mislead you. You are right, it was aluminium sheet that I got from Europa, which is why I laquer coated it to stop it going dull and tarnishing if it got wet, which good quality stainless shouldnt do. Sorry to cause confusion.

I got my rivnut tool from Car Builder Solutions. Have a look at their website as a starter. You may find that its not worth hiring for the extra cost in buying.

Cheers

Marty