Search:

Type: Posts; User: jon1d; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    10
    Views
    566

    Your volts drop sounds like your issue. Fan draw...

    Your volts drop sounds like your issue.
    Fan draw is a high current draw and if your alternator is not keeping pace with all the consumption your ECU might not have enough voltage..
    Run the engine...
  2. Replies
    49
    Views
    2,842

    There is a difference between the two. PL700 is...

    There is a difference between the two. PL700 is beam throw left or right handed while P700 is straight dip beam and not handed. So a PL700 will light up the verge more .
  3. Replies
    30
    Views
    3,952

    Those reinforcement bearings look spot on. If you...

    Those reinforcement bearings look spot on. If you can get your end float plus minus 1 -3 using shims if needed when tightened . I cannot recall the final torque setting but using the reinforcement...
  4. Yes, very little on the engine description and no...

    Yes, very little on the engine description and no under floor suspension fuel tank photos which usually get shown.

    I would say its treated just as any import. MOT'ed DVLA issued reg on age.
  5. Up for auction 2001 SUPERFORMANCE MKIII COBRA

    Nice looking car and engine. Nothing to do with me.

    https://collectingcars.com/for-sale/2001-superformance-mkiii-cobra
  6. Replies
    10
    Views
    619

    Ideally you need your expansion tank to be your...

    Ideally you need your expansion tank to be your highest point which will push out any air on fill up. If the pipe is the highest point will have trapped air. As Kevin says fit a bleed nipple at this...
  7. Hi have always had to size down photos below 2meg...

    Hi have always had to size down photos below 2meg file sizes before I can upload .
  8. Hi Gary, Happy to upload your photos. It...

    Hi Gary,

    Happy to upload your photos. It usually is photo size to large or size format. I will pm you my e-mail.
  9. Replies
    2
    Views
    383

    Well sold for £28k. RAM with Chevy is a nice...

    Well sold for £28k. RAM with Chevy is a nice car. It does amaze me the stigma of a Q plate which does devalue the final bid.
  10. Replies
    5
    Views
    447

    I would just measure the resistance values by...

    I would just measure the resistance values by swing the float this should prove the float is good. Then connect it up to the 12v feed and earth it. First check you in fact have a 12v fused supply ! ...
  11. Replies
    5
    Views
    281

    Nice colour. I think the new blue white strips is...

    Nice colour. I think the new blue white strips is now grey/silver which is becoming popular. I have seen a few now and would be going this way on a new build.
    I mounted a black painted grill x2 in...
  12. Replies
    19
    Views
    531

    I would check that your alternator is working...

    I would check that your alternator is working correctly as Chris1 says . You have voltage where you should not. The usual problem is the lamp does not going out with the engine running which shows...
  13. Replies
    19
    Views
    531

    The Alternator IGN side should be connected one...

    The Alternator IGN side should be connected one side to the non live side of the switch too the bulb or lamp ( Led work a bit different.). So the lamp is off . Could you be wired to the live side of...
  14. Replies
    11
    Views
    1,697

    Nice to see the build blog.

    Nice to see the build blog.
  15. Replies
    6
    Views
    586

    The set up is different for 15 inch and 17 inch...

    The set up is different for 15 inch and 17 inch wheels and de-Dion and standard Jag. You will have the MKiv chassis so the geometry should be good to eliminate any bump steer. This can be checked....
  16. Replies
    36
    Views
    3,840

    I would save a lot of time and effort. Get a...

    I would save a lot of time and effort. Get a soda blaster kit . Makes a mess save you a lot of time.
  17. Replies
    36
    Views
    3,840

    On the same site they offer an out rigger kit or...

    On the same site they offer an out rigger kit or complete chassis.

    https://www.sportmotive.com/tvr-body-and-chassis/tvr-chassis-outriggers/

    Some nice prices which make the cobra chassis and...
  18. Replies
    1
    Views
    351

    Pilgrim part build

    This might be of interest.

    https://www.ebay.co.uk/itm/265305607315?hash=item3dc5724c93:g:Kj0AAOSwe7lhObny
  19. Replies
    3
    Views
    511

    The photos I have attached show two different...

    The photos I have attached show two different cars one which is cut away the bonnet shut line surely will allow water directly onto the alternator. Not good. Why has it been cut away is the question....
  20. Replies
    3
    Views
    511

    Alternator fitting with LS3 engine

    Alternator fitting and cutting the body with LS3.

    What is the story behind mounting an alternator on LS3. I have seen on a 2008 AK the bonnet shut area cut away but the engines look lower mounted...
  21. Replies
    621
    Views
    98,407

    Yes tastes do change. I guess the car was going...

    Yes tastes do change. I guess the car was going to be yellow?
  22. Replies
    36
    Views
    3,840

    Looks in good condition. Is the chassis rotten....

    Looks in good condition. Is the chassis rotten. TVR seem to suffer.
  23. Replies
    69
    Views
    60,875

    North Weald Airfield @ old Squadron cafe far end....

    North Weald Airfield @ old Squadron cafe far end.
    10.00 a.m. Sunday 12th Sept . More details on facebook page.

    https://www.facebook.com/groups/170236225077355/permalink/219924250108552/
  24. Thread: Radiator caps.

    by jon1d
    Replies
    28
    Views
    1,358

    Some times the simplest things work. You end up...

    Some times the simplest things work. You end up chasing a problem which is not there. All will become will become clear. Working off a good bench mark with your IR gun will give you the confidence...
  25. Thread: Radiator caps.

    by jon1d
    Replies
    28
    Views
    1,358

    Another way to prove your temperature gauge is ok...

    Another way to prove your temperature gauge is ok . Do you know your thermostat opening temp ( Should be 82c or 85c) Watch from start off and you should see the temp rise on the gauge, hit the 82/85c...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4