Search:

Type: Posts; User: Mark_Robinson; Keyword(s):

Page 1 of 16 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    230

    At which point in the process, did they think...

    At which point in the process, did they think they had a great idea? I'm struggling to get past that thought...
  2. Replies
    3
    Views
    216

    I might try to come (with or without a Cobra). ...

    I might try to come (with or without a Cobra). I'll pencil the dates in the calendar so i don't forget.
    Cheers,
    Mark
  3. Thread: 2021

    by Mark_Robinson
    Replies
    4
    Views
    369

    Happy New Year Everyone. Hopefully the vaccine...

    Happy New Year Everyone. Hopefully the vaccine will be rolled out quickly enough so we can start to get some normality back in our lives and enjoy going out for runs in the cars soon.
  4. Replies
    48
    Views
    3,522

    I built most of mine in a single garage. It was...

    I built most of mine in a single garage. It was fine until i needed to roll it out and onto the upward sloped drive (problems with the clutch so couldn't drive it out).

    My biggest take away advise...
  5. Replies
    10
    Views
    599

    Looking good.

    Looking good.
  6. Replies
    0
    Views
    376

    Edelbrock SBC350 rocker covers

    I've recently replaced my rocker covers because the old ones were rusting. They are the Edelbrock Chrome plated type suitable for the SBC350. It feels wrong throwing them out so i thought i'd offer...
  7. Replies
    3
    Views
    385

    It's a got a wonderful charm about it.

    It's a got a wonderful charm about it.
  8. Replies
    6
    Views
    267

    I tried to use a speedometer app on my phone and...

    I tried to use a speedometer app on my phone and found it really wasn't very accurate.
  9. Replies
    17
    Views
    1,796

    I used one of these ...

    I used one of these

    https://www.ebay.co.uk/itm/221865539832

    and it came with the thick and thin gaskets. I tried the think gasket and there was a visible gap so the oil leaked. I tried the...
  10. Replies
    16
    Views
    2,112

    That's the set myself and brother used to have. I...

    That's the set myself and brother used to have. I moved on to a Ford Escort XR3 and Lancia 037 later on. I seem to have lost them both though. When i was around 25 my brother bought me another set...
  11. Replies
    5
    Views
    1,164

    I think my Dax will end up being a very poor...

    I think my Dax will end up being a very poor approximation of that one. Such a beautiful car.
  12. Replies
    5
    Views
    1,164

    Jay Leno Youtube video

    https://www.youtube.com/watch?v=eVxSqnNQR9s

    definately worth a look.
  13. Replies
    21
    Views
    1,454

    We have a dehumidifier in the garage and in the...

    We have a dehumidifier in the garage and in the middle of winter, it's useless. The air temp is too cold for it to be effective. I would agree that the best course of action is to reduce the...
  14. Replies
    4
    Views
    422

    From the photo, they do look the same as mine. ...

    From the photo, they do look the same as mine.
    I vaguely remember the mounting brackets being a very snug fit on the engine mounts when i fitted it though.
  15. Replies
    4
    Views
    422

    have you got any photos? We can see if they are...

    have you got any photos? We can see if they are different to the mounts on mine (SBc in a Dax).

    Cheers,
    Mark
  16. The Worcester Bosch one ticks those boxes but I'm...

    The Worcester Bosch one ticks those boxes but I'm assuming it will only play nicely with a Worcester Boiler.
  17. I've got a Worcester Bosch one that seems to work...

    I've got a Worcester Bosch one that seems to work OK. It doesn't have an app for the phone though. Just a wireless thermostat and control panel.
  18. Replies
    69
    Views
    9,547

    woo hoo. brilliant news.

    woo hoo. brilliant news.
  19. Replies
    5
    Views
    748

    I wanted to be extra safe so I wrapped it all...

    I wanted to be extra safe so I wrapped it all again in spiro wrap. It's a bit of a pain in the a*se to fit but it gives a little more protection.

    Cheers,
    Mark
  20. Replies
    10
    Views
    1,069

    Admittedly i haven't run mine much since the...

    Admittedly i haven't run mine much since the engine was built so haven't needed many oil changes but i didn't even consider pre-filling it. I'm not sure i fancy the idea of trying to screw it in...
  21. Replies
    30
    Views
    4,127

    They look similar in style to the existing ones...

    They look similar in style to the existing ones I've got but must be sufficiently different to allow the bracket & mirror to flex to suit mounting on the windscreen frame.
  22. Replies
    30
    Views
    4,127

    Thank you for the help everyone. It's very much...

    Thank you for the help everyone. It's very much appreciated.
  23. Replies
    30
    Views
    4,127

    Just a thought. Do you know what size the screws...

    Just a thought. Do you know what size the screws are that hold the bracket onto the windscreen frame? I could re-purpose the existing mirrors onto brackets similar yours.

    Cheers,
    Mark
  24. Replies
    30
    Views
    4,127

    Are these the ones? ...

    Are these the ones?

    https://www.carbuilder.com/uk/lightweight-aluminium-gp-mirror-polished-100mm
  25. Replies
    30
    Views
    4,127

    Morning, It's a Dax but i'm using a Brasscraft...

    Morning,
    It's a Dax but i'm using a Brasscraft windscreen bought from Europa. It's got the 2 screwholes intended for the windwings that i could use. Onother idea would be if there are any clamp on...
Results 1 to 25 of 376
Page 1 of 16 1 2 3 4