Search:

Type: Posts; User: GDCobra; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: Radiator caps.

    by GDCobra
    Replies
    28
    Views
    1,094

    Either way it's best to have the top seal (better...

    Either way it's best to have the top seal (better to have and not need than need and not have IMO) but really needed where a header is used to allow the low pressure caused by the coolant, er,...
  2. Thread: Radiator caps.

    by GDCobra
    Replies
    28
    Views
    1,094

    I suspect the didn't have the upper seal where no...

    I suspect the didn't have the upper seal where no expansion tank was used, not required to seal against low presure to draw coolant back if there's nowhere to draw it from.
  3. Replies
    19
    Views
    2,112

    Needle moved on shaft maybe?

    Needle moved on shaft maybe?
  4. Replies
    35
    Views
    3,030

    :-) And can be similar to not stepping back...

    :-)
    And can be similar to not stepping back quick enough when someone asks for a volunteer!
  5. Replies
    10
    Views
    941

    Wouldn't that be difficult and possbly dangerous...

    Wouldn't that be difficult and possbly dangerous to do, even with a long lenght of hose?
  6. Replies
    10
    Views
    941

    Is your idle vacuum going to be a problem even if...

    Is your idle vacuum going to be a problem even if it is low?
    The servo should act as a vacuum reservoir and presumably the vacuum will increase when RPM increase (even if the engine stops you...
  7. Replies
    19
    Views
    2,316

    I think Arthur Conan Doyle May have said it first...

    I think Arthur Conan Doyle May have said it first though.
    strange that bad fuel should stop several pumps pumping.
  8. Replies
    23
    Views
    2,169

    Agree with most most of that but in my case I...

    Agree with most most of that but in my case I chose a concentric slave which would give more ore less the same release bearing motion for a given degree of pedal motion, taking into account the...
  9. Replies
    23
    Views
    2,169

    Ah, yes that would have the opposite effect. I...

    Ah, yes that would have the opposite effect.

    I also eventually went to a concentric release bearing which has helped lighten the pedal to some extent without increasing travel (may be even less...
  10. Replies
    23
    Views
    2,169

    The larger master master cylinder should give you...

    The larger master master cylinder should give you a harder (but shorter) pedal not softer/easier
    I fitted a 1” for just that reason.
  11. Got bored quite quickly as it seemed to be an...

    Got bored quite quickly as it seemed to be an exercise in statin* th3 bleeding obvious.

    Dont see the benefit of Hydrogen, takes a lot of energy to separate it from its partners and current...
  12. Replies
    17
    Views
    2,021

    Has anybody heard of or tried removing the...

    Has anybody heard of or tried removing the Ethanol by adding water and then draining it off? Obviously would have to be done in some kind of jerry can and not possible when out and about but may be...
  13. Replies
    9
    Views
    1,004

    That's another good reason for outboard brakes,...

    That's another good reason for outboard brakes, heat messing with handbrake pads not such an issue but melting diff' seals more likely to end in tears.
  14. Replies
    19
    Views
    2,316

    That's a good point, I did have a (single) fuel...

    That's a good point, I did have a (single) fuel pump failure on my car a few years ago, pump was quite old and car had been stored for a while (couple of years) and not used at all, not even spun...
  15. Replies
    19
    Views
    2,316

    But you’d think a quick bench test of the pump...

    But you’d think a quick bench test of the pump would be in order before condemning it wouldn’t you? Particularly when it got to number 4. I’d have been making sure before I replaced the first...
  16. Replies
    19
    Views
    2,316

    Could be but I’d have thought if that were the...

    Could be but I’d have thought if that were the case the pump would not achieve correct pressure on the rail and the engine would run poorly or not at all.
    Of course when a problem has a mystery...
  17. Replies
    19
    Views
    2,316

    Must admit I don’t quite see the logic of...

    Must admit I don’t quite see the logic of swapping the ECU or AFM if the problem lies with the fuel pump.

    Not too familiar with flapper system but would have thought the EFi system only gives a...
  18. Thread: Fuel filling

    by GDCobra
    Replies
    14
    Views
    1,586

    Many years ago I was told about an issue where a...

    Many years ago I was told about an issue where a tank breather had become blocked and the fuel pump has still managed to suck out enough fuel to deform the tank under the vacuum.
    Very unlikely it's...
  19. That doesn't sound good Jim?

    That doesn't sound good Jim?
  20. Replies
    6
    Views
    1,132

    So am I, which is why I prefer Titanium over...

    So am I, which is why I prefer Titanium over Carbon these days.






    For the frame at least. Gives a much smoother ride.
  21. Thread: Time to Watch

    by GDCobra
    Replies
    19
    Views
    1,446

    Cheers Chris, you've almost made up my mind....

    Cheers Chris, you've almost made up my mind.
    Funny thing is I find guitar's similar to Cobras in a way. When they're in the right shade of blue I find it very hard to refuse them.




    Then...
  22. Thread: Time to Watch

    by GDCobra
    Replies
    19
    Views
    1,446

    I have a similar problem with guitars. Got my...

    I have a similar problem with guitars. Got my eye on a nice USA Fender Tele at the moment.
  23. Replies
    17
    Views
    1,112

    The condensate I use is from my de-humidifier. ...

    The condensate I use is from my de-humidifier. Was a bit concerned by this so I've tested it and found it is PH neutral, don't know if different in a boiler but don't see why it would be sulphuric...
  24. Replies
    17
    Views
    1,112

    I better stop drinking it then, no wonder my eyes...

    I better stop drinking it then, no wonder my eyes keep lighting up.
  25. Replies
    35
    Views
    3,030

    May be longer than the average build time then!

    May be longer than the average build time then!
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4