Search:

Type: Posts; User: Robo; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    731

    Hi guys, I've had the same issue with my gen 3,...

    Hi guys, I've had the same issue with my gen 3, LS3 and Tremec 500 box and found that it does need correcting to centre the output shaft. I have also watched the video and at the end he does say...
  2. Thread: Heater

    by Robo
    Replies
    3
    Views
    444

    Heater

    Hi all, am currently half way through my build and have read that the heater must not draw air from beneath the bonnet. I have a heat 3 from CBS and have seen some other builders fabricate a cover. ...
  3. Replies
    9
    Views
    986

    Guys many thanks for your replies I have just...

    Guys many thanks for your replies I have just found out that the ECU kit I've ordered from AK comes with all the sensors and a fuel pressure regulator so therefore I'll wait and see what arrives.
  4. Thread: Rear end geometry

    by Robo
    Replies
    22
    Views
    2,229

    Having read everyone's comments I decided to look...

    Having read everyone's comments I decided to look at mine too and can confirm that the right hand outer roll bar mount is 10mm further out than the left, which at first didn't concern me. Then I...
  5. Replies
    9
    Views
    986

    Fuel pressure regulator

    Hi all,. Had an exiting day yesterday when my new LS3 turned up 😊 however I'm now a little confused as to what to do about the return connection. I have seen that some people use a Wix combined...
  6. Thread: Clutch line size

    by Robo
    Replies
    7
    Views
    806

    Many thanks for your replies looking on a lot of...

    Many thanks for your replies looking on a lot of blogs and YouTube vids I think the clutch pipe is one line size more than the brake. When I mentioned feel I really meant how heavy the peddle would...
  7. Thread: Clutch line size

    by Robo
    Replies
    7
    Views
    806

    Clutch line size

    Dear all,

    I have received my AK gen 3 kit and like most my planning brain is ahead of my install. I have ordered a LS3 with Tremec 500 gear box but have read somewhere that the clutch line would...
  8. Thread: Drive shafts

    by Robo
    Replies
    10
    Views
    766

    Thank Paul, the manual also says to tap them...

    Thank Paul, the manual also says to tap them through so I'll try this too and cut them as a last resort.
  9. Thread: Drive shafts

    by Robo
    Replies
    10
    Views
    766

    Drive shafts

    Hi all,. Could someone give me some guidance on how to break down the drive shafts? AK require the centre section for modification but I'm not sure how to remove the old spider? Do you just press it...
  10. Thread: Sterring column

    by Robo
    Replies
    3
    Views
    1,128

    Hi Paul, many thanks for the link and have...

    Hi Paul, many thanks for the link and have contacted the seller to see what deal I can make.
    Regards Ian
  11. Thread: Sterring column

    by Robo
    Replies
    3
    Views
    1,128

    Sterring column

    Hi this is my first of probably many pleas for help!

    I have ordered an AK 427 gen 3 kit and amongst the many parts required they recommend a pre air bag BMW E34 sterring column. A local BMW...
Results 1 to 11 of 11