Search:

Type: Posts; User: richard8166; Keyword(s):

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    187

    Fuel filler cap venting playing up?

    Fuel filler cap venting playing up?
  2. Replies
    3
    Views
    235

    Brass fittings on Cunifer brake line won't...

    Brass fittings on Cunifer brake line won't corrode. If you have aluminium calipers, then brass fittings into them may not be the best idea due to galvanic corrosion. If you have cast iron calipers...
  3. Replies
    12
    Views
    1,853

    We're just going on the Saturday. No spare...

    We're just going on the Saturday. No spare tickets.
    Looking forward to it!
  4. Replies
    2
    Views
    397

    Congratulations. Hope you had a good first trip!...

    Congratulations. Hope you had a good first trip!
    Sound like it wasn't you I saw. Not quite sure which type of cobra I saw in the 2 seconds, but maybe a Dax. There were 2 in the car, but that's about...
  5. Replies
    2
    Views
    397

    Blue on A10

    Just saw a rather good looking blue cobra on the A10, going northbound in Stretham just north of Cambridge. 1.30pm Saturday 28 June.
    Very nice day for it!
  6. Replies
    13
    Views
    959

    I understand that it's a converted tacho, so...

    I understand that it's a converted tacho, so whoever converted it probably used a component such as this http://www.ti.com/lit/ds/symlink/lm2917-n.pdf inside. It converts the pulses from the...
  7. For painting it yourself, the MIG welding forum...

    For painting it yourself, the MIG welding forum has a good guide, and the forum has lots of helpful advice!
    https://www.mig-welding.co.uk/spray-painting.htm
    Well worth a look. The guide is a bit...
  8. Replies
    5
    Views
    512

    There was a later mk2 specifically for the RV8 as...

    There was a later mk2 specifically for the RV8 as mogsy suggests. I had one. The chassis had an extra cross member between the main rails under the front part of the RV8 sump compared to earlier...
  9. The cancellation is very recent. I'd been...

    The cancellation is very recent. I'd been looking at their website at the start of this week as we'd been planning on a visit one of the days, and the cancellation wasn't showing at that point. ...
  10. Replies
    38
    Views
    2,833

    My daughter and I camped and enjoyed the weekend,...

    My daughter and I camped and enjoyed the weekend, but I was surprised again by the reduction in number of traders. Good number of cars, but maybe down on numbers compared to last year due to the...
  11. Replies
    6
    Views
    554

    http://www.cobraclub.com/forum/attachment.php?atta...

    http://www.cobraclub.com/forum/attachment.php?attachmentid=37448&stc=1
    Slightly better view?
  12. Replies
    6
    Views
    554

    I had a nose at the HS2 plans regarding...

    I had a nose at the HS2 plans regarding Stoneleigh Park. Interesting... Plan is to run right through the park, and explains why the stand needs to move....
  13. Replies
    33
    Views
    4,015

    Yes, that's a reasonable way to isolate the rear,...

    Yes, that's a reasonable way to isolate the rear, but you might see less drop at the front because the rear will have to lift the whole weight instead of being helped by the rear springs, as the sag...
  14. Replies
    33
    Views
    4,015

    Some ideas. Your problem could well be in the...

    Some ideas. Your problem could well be in the rear suspension. I assume the rear is mk2 Granada. It sort of sounds like something is moving when jacked up, and the settling down after a few bounces....
  15. Replies
    33
    Views
    4,015

    I'm surprised that your original springs were...

    I'm surprised that your original springs were longer. Maybe a change in the mk2 chassis design. As I'd said, my old car had compressed front spring length of 8.8 inches, your car must have been...
  16. Replies
    33
    Views
    4,015

    Are the chassis rails the same height from the...

    Are the chassis rails the same height from the ground on both sided where the lower wishbones mount? If so, then something must have happened to make the bodywork sag on that side. If not, then as...
  17. Replies
    33
    Views
    4,015

    Looking forward to the pictures :-)

    Looking forward to the pictures :-)
  18. Replies
    3,022
    Views
    529,540

    Side windows are just GD standard type. 5mm...

    Side windows are just GD standard type. 5mm perspex type glass mounted to a pair of wind wing hinges. A rotating catch hooks round the hood hoop to keep them shut, and a good size rubber strip on the...
  19. Replies
    3,022
    Views
    529,540

    Fitted side screens at last. Testing this...

    Fitted side screens at last. Testing this weekend :-)

    http://www.cobraclub.com/forum/attachment.php?attachmentid=37385&stc=1
  20. I can when I get home this evening. Cheers,...

    I can when I get home this evening.
    Cheers, Richard
  21. The code is still valid until 31st May. You just...

    The code is still valid until 31st May. You just don't get the early bird pricing after 31st March.
  22. Replies
    33
    Views
    4,015

    Yes, original Cortina front arms. It was a few...

    Yes, original Cortina front arms.
    It was a few years ago now, but I spent too long calculating new spring rates ;-)
  23. Replies
    33
    Views
    4,015

    Hi Alex, What is your compressed front spring...

    Hi Alex,
    What is your compressed front spring length? A reasonable rstone of front corner weight is 530lbs, so with a 240lbs/in spring you should expect about 2.2in of compression. 260lbs/in gives...
  24. Replies
    33
    Views
    4,015

    If you wanted uprated springs, it looks like...

    If you wanted uprated springs, it looks like rally design do the cortina v6 front springs in 1" drop. These are 275lbs/in.
    http://www.rallydesign.co.uk/product_info.php?products_id=9414
  25. Replies
    33
    Views
    4,015

    http://www.cobraclub.com/forum/attachment.php?atta...

    http://www.cobraclub.com/forum/attachment.php?attachmentid=37144&stc=1
    Here is a picture of the springs.
    As I said, if you want them you can have them. If you can wait, I'll be at the kit car...
Results 1 to 25 of 120
Page 1 of 5 1 2 3 4