Page 73 of 77 FirstFirst ... 23637172737475 ... LastLast
Results 721 to 730 of 762
  1. #721
    Join Date
    Jan 2006
    Location
    Chelmsford Essex
    Posts
    789
    Might be of help if you go with the pilgrim ones.

    https://pilgrim-motorsports.co.uk/Ca...ion_Manual.PDF

  2. #722
    Join Date
    Jan 2006
    Location
    Chelmsford Essex
    Posts
    789

  3. #723
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    Classic Replica Viper currently in build

  4. #724
    Join Date
    Nov 2012
    Location
    Lanarks
    Age
    63
    Posts
    102
    Bonnet hinge and door hinge from round bar and flat bar with a few round tubes
    I found the Jag inner spacers were ideal for this application.

    Have a go and save some £££

    Like the idea from the previous post showing the video of bear claw latch installation.....
    Attached Images Attached Images

  5. #725
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    So after a nice sunny two week family villa holiday in Portugal done and a week back at work I am back at it.
    Classic Replica Viper currently in build

  6. #726
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    I fitted my home made closer panel at the front of the rear arch on the drivers side and glassed it in




    Rear bulkhead glassed top and bottom on drivers side




    Closer panel viewed from inside the arch




    Last top area of the arch closed off




    Rear of the arch closed off to the boot panel on the underside of the car




    Finally the boot liner panel was glassed to the arch panel inside the boot area

    Classic Replica Viper currently in build

  7. #727
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    That's the rear of the car all glassed now, very happy to close that chapter of the build off
    Classic Replica Viper currently in build

  8. #728
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    I decided to see how the boot panel fitted. It was not much of a surprise to see it needed fettling!!!

    Drivers side



    Passenger side



    Front



    Bottom edge
    Classic Replica Viper currently in build

  9. #729
    Join Date
    Oct 2017
    Location
    Oxford
    Posts
    616
    I decided to attack the boot panel with the DA machine and a 120 grit pad.

    After about an hour of sanding, offering up, marking, re-offering etc, this is the result. It still needs work but at least it goes in the hole now!

    I think the next step will be to hinge it to see how it operates and then once thats done work on the gap lines to even them up.


    Drivers side



    Passengers side



    Front edge


    Classic Replica Viper currently in build

  10. #730
    Join Date
    Jan 2006
    Location
    Chelmsford Essex
    Posts
    789
    You going internal hinges? The gaps look pretty good and you will not nee to do a lot of work. I have external boot hinges and think the strain on the fibreglass needs a metal plate on the inside which I will look to install.

Page 73 of 77 FirstFirst ... 23637172737475 ... LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •