M10 I think. Anyone?
Evening All, can somebody tell me the bumper stud size on a Dax, I want to change the bumpers for quick lifts and dome nuts. Cheers.
M10 I think. Anyone?
DAX Cobra. May contain nuts. Always read the label.
That's certainly what my Brasscraft bumpers are; I assumed they were all the same but I suppose you never know![]()
My DeDion build diary..
Hon Sec of the Digidash branch of the Unpopular Kit Car Design club
Some have used 3/8 unc but most commonly it’s m10
Early RAM cars use 7/16 unf. I know that's not a Dax but there were quite a few relationships between the two. I would get out the vernier and a thread gauge or just buy an m10 nut and check.
Thanks again guys, the car is in storage 20 miles away so can't measure, I'll take a gamble and order up some M10s.
My AK and my mates Dax both used M10 This is what the overiders required
Martin
351W 416.7 HP and 466.8 ft-lbs
Running Mega Squirt and Edis 8
Bookmarks