Results 1 to 3 of 3

Thread: Speedo Cable

  1. #1
    Join Date
    Feb 2007
    Location
    Southend On Sea, UK.
    Posts
    292

    Speedo Cable

    My speedo cable traveling from the clock to the Tremec box has a small metal 'tang' attached. This assembly was supplied by DAX. Presumably, it is intended to hold one of the ends of the cable to either the clock or the gear box. Anybody know how which and where?

    RigMan

  2. #2
    Join Date
    May 2001
    Location
    Buntingford, Herts.
    Posts
    736

    RE: Speedo Cable

    Hi there
    My cable from Dax (SW gauges)didn't have any extra bits on it but then I'm using a T5 (GM)box the thing I did fit was a right angle drive (Speedy cables approx 40) from the gear box because the bend in the cable looked a bit tight
    you could try talking to Gary at Dax and see what he has to say about it
    Paul

  3. #3
    Join Date
    Feb 2007
    Location
    Rushden, Northamptonshire, UK.
    Posts
    101

    RE: Speedo Cable

    Hi Rigman

    I've got a Tremec on my Cobra. The end with the metal tag goes into the gearbox and is held in with a small bolt.

    John

Similar Threads

  1. Speedo Cable Length
    By lomondbob in forum DAX Technical Questions
    Replies: 2
    Last Post: 21-07-07, 06:58 PM
  2. Smith's to Tremec Speedo cable
    By Dax SC in forum General Tech Tips & Questions
    Replies: 3
    Last Post: 17-03-03, 07:07 AM
  3. Speedo cable RV8 and Heater fan
    By Zeb_1970 in forum General Tech Tips & Questions
    Replies: 2
    Last Post: 31-12-02, 06:31 PM
  4. Speedo cable
    By Zeb_1970 in forum General Tech Tips & Questions
    Replies: 2
    Last Post: 15-11-02, 01:11 PM
  5. Speedo cable drive
    By RigMan in forum General Tech Tips & Questions
    Replies: 3
    Last Post: 03-07-01, 08:25 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •